RC Discharger XT90-M to XT60-F, XT90-F or Bare Wire

Description

RC Discharger XT90-M to XT60-F, XT90-F or Bare Wire

XT90 adapter cable performance matters when every milliohm affects lap time. Therefore, this short lead helps prevent heat and voltage drop. Moreover, it keeps discharge data clean during hard regenerative cycles.

The Professional Standard for High-Amperage Power

In racing, wiring bottlenecks steal power and add parasitic heat. Consequently, your charger may read wire loss instead of pack voltage. This adapter bridges your charger and RC Discharger hardware for efficient current flow.

Engineering excellence that stays cool

First, we spec thick conductors to reduce resistance. Additionally, we keep the run short to protect accuracy. As a result, your setup stays tidy and repeatable.

Engineering Excellence

Superior 10AWG Silicone Wire

We upgraded to 10AWG high-strand silicone wire for high current work. Therefore, the larger copper area helps carry current with less heat. Moreover, the flexible jacket resists tears and stays easy to route.

High-Current EC8 Integration

Next, the cable uses an XT90-M Male connector for a secure click-lock fit. Consequently, you get solid contact through repeated cycles. In addition, the large contact area supports the raw power of 2S discharge loads.

Optimized 12cm Length

Finally, the 12cm length hits a practical balance for race benches. Thus, you avoid the added resistance of long leads. Meanwhile, you still get enough slack for clean routing around your charger.

Compatibility and interface options

This XT90 adapter cable works across the RC Discharger lineup and common chargers. For example, you can match XT60, XT90, or bare-wire ends to your exact bench needs. Additionally, XT connectors use spring contacts to keep resistance low under load, as explained in XT60 connector design and current handling.

Full Compatibility List

Compatible with the entire RC Discharger high-performance lineup:

• Regenerative Discharger 2S (Standard & Air Travel)

Choose Your Charger Interface

• XT90-M to XT60-F (Female): For your iCharger X6, X8 and X12.
• XT90-M to XT90-F (Female): For iCharger S6, DX6, DX8, DX12 and ToolkitRC M8D.
• XT90-M to Bare Wire: Pre-stripped 10AWG leads for custom bullet connectors or direct soldering.

Performance benefits on race day

Above all, this cable targets repeatable results under high current. Therefore, you can trust the data you log between heats. Moreover, you reduce stress on connectors and packs.

• Heat Reduction: 10AWG gauge dissipates thermal energy effectively.
• Zero Voltage Sag: Your charger reads the battery’s true state, not the wire’s resistance.
• Pro-Grade Durability: Tear-resistant silicone remains flexible in any track environment.
• Purpose-Built: An integral component of the RC Discharger ecosystem.

Ultimately, the XT90 adapter cable helps you protect accuracy, reduce heat, and keep your pit wiring professional.