The Power Supply RC Discharger is designed to fit our discharge bank. Compact and powerful, it comes with an AC port and 2 outputs 12V and 2 outputs 24V to provide maximum connectivity for chargers and other accessories.
Specifications: Input: AC 100/240V Output: 1500W 62.5A / 1800W 75A Size: 3.5″(89mm) x 3.2″(82mm) x 9.4″(238mm)
The Power Supply RC Discharger is designed to fit our battery dischargers. Compact and powerful, it comes with an AC port and 3 bullets ouput to provide maximum connectivity for chargers and other accessories. It includes a protection plate to keep outputs safe from damage or breakage.
Specifications: Input: AC 100/240V Output: 750W 62.5A / 900W 75A Size: 1.5″(38mm) x 3.5″(89mm) x 8.6″(218mm)
The RC Discharger Charger Stand was developed to allow you to mount a Junsi iCharger 406DUO, 308DUO, 4010DUO, two X6 or two X8 chargers on top of your Power Supply. With our Charger Stand, no problem of balance. This charger stand is small, perfect for traveling.
* Power supply recommended Width 8.6in (218mm), Depth 3.5in (89mm)andĀ Height 1.5inĀ Ā (38mm) ** Power supply and charger aren’t included
This RC Discharger Charge Cable is assembled with the stepped 5mm bullets.
This charger cable uses 8 gauge wires recommended for charge or discharge at 70A wrapped in nylon mesh, plus stepped bullets so you can charge only 5mm batteries.
Bridge Synchronous for existing Charge Cable iCharger to charge at 70A. 2 plugs male 5mm are included to change the plugs on your existing cable. Your charge cable have to be in 10 AWG minimum.
This RC Discharger Charge Cable isĀ assembled with the stepped 4/5mm bullets.
This charger cable uses 10 gauge wires recommended for charge or discharge at 40A wrapped in nylon mesh, plus stepped bullets so you can charge both 4mm and 5mm batteries and XH connector on the charger side.